MATERIAL SAFETY DATA SHEET

Date-Issued:   07/05/2000 MSDS Ref. No:   10023 Date-Revised:   08/23/2004 Revision No:   1

New Car Solvent

1. PRODUCT AND COMPANY IDENTIFICATION

PRODUCT NAME:  New Car Solvent

PRODUCT DESCRIPTION:  Tar Remover

PRODUCT CODE:  23

PRODUCT FORMULATION NAME:  New Car Solvent

GENERIC NAME:  Tar Remover

COMMENTS: To the best of our knowledge, this Material Safety Data Sheet conforms to the requirements of US OSHA 29 CFR 1910.1200.

2. COMPOSITION / INFORMATION ON INGREDIENTS

COMMENTS: Product composition ranges shown are typical values for health, safety and environmental use and are not intended as specification.

3. HAZARDS IDENTIFICATION

EMERGENCY OVERVIEW

IMMEDIATE CONCERNS: Flammable liquid and vapor. CAUTION! May cause eye irritation.

POTENTIAL HEALTH EFFECTS

EYES: Moderately irritating to the eyes.

SKIN: May cause slight irritation.

INGESTION: Harmful if swallowed.

INHALATION: Repeated of prolonged inhalation may cause toxic effects.

SIGNS AND SYMPTOMS OF OVEREXPOSURE

EYES: Eye contact may cause redness, tearing and a burning sensation.

SKIN: Repeated or prolonged skin contact may cause redness and irritation.

INGESTION: Ingestion may cause nausea and irritation.

INHALATION: High concentrations may lead to central nervous system effects (drowsiness, dizziness, nausea, headaches, paralysis and loss of consciousness).

ACUTE TOXICITY: overexposure to vapors may cause headaches, dizziness, confusion and nausea,

CHRONIC: not available

CARCINOGENICITY: not available

REPRODUCTIVE TOXICITY

TERATOGENIC EFFECTS: not available

MEDICAL CONDITIONS AGGRAVATED: dermititis may be aggravated by excessive exposure to skin.

ROUTES OF ENTRY: include skin contact, skin absorption, eye contact , inhalation and ingestion

TARGET ORGAN STATEMENT: not available

CANCER STATEMENT: not available

SENSITIZATION: not available

HEALTH HAZARDS: Moderately irritating to the eyes.

PHYSICAL HAZARDS: Flammable liquid.

4. FIRST AID MEASURES

EYES: Flush eye with water for 15 minutes. Seek medical attention if irritation persists.

SKIN: Remove contaminated clothing. Wash with soap and water.

INGESTION: Do not induce vomiting. Seek medical attention immediately.

INHALATION: Remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Get medical attention.

5. FIRE FIGHTING MEASURES

FLASHPOINT AND METHOD: ~ -6°C TCC

FLAMMABLE LIMITS: Not Available

AUTOIGNITION TEMPERATURE: Not Available

FLAMMABLE CLASS: Extremely Flammable. Material will readily ignite at room temperatures.

GENERAL HAZARD: Flammable liquid. Keep away from heat and open flames.

EXTINGUISHING MEDIA: use foam, dry chemical or cabon dioxide extinguisher

HAZARDOUS COMBUSTION PRODUCTS: Carbon Monoxide and Carbon Dioxide

OTHER CONSIDERATIONS: "EMPTY" container retain residue (liquid and/ or vapor) and can be dangerous. Do not expose container to heat, flame, sparks or other sources of ignition.

EXPLOSION HAZARDS: not available

AUTOIGNITION TEMPERATURE: not available

FLAMMABLE LIMIT: not available

SENSITIVE TO STATIC DISCHARGE: Yes, use proper grounding procedure.

SENSITIVITY TO IMPACT: not available

6. ACCIDENTAL RELEASE MEASURES

SMALL SPILL: Remove all ignition sources.Contain and collect with absorbent

LARGE SPILL: Remove all ignition sources. Shut off leak if safe to do so. Contain material to avoid run off and collect spill with absorbent.

ENVIRONMENTAL PRECAUTIONS

WATER SPILL: Avoid runoff into storm sewers and ditches which lead to waterways.

7. HANDLING AND STORAGE

GENERAL PROCEDURES: Keep out of reach of Children.

STORAGE: Keep away from open flames and excessive heat.

STORAGE TEMPERATURE: (32°F) minimum to (95°F) maximum

SHELF LIFE: one year

ELECTROSTATIC ACCUMULATION HAZARD: Ground and bond containers when transferring material.

8. EXPOSURE CONTROLS / PERSONAL PROTECTION

EXPOSURE GUIDELINES:

OSHA HAZARDOUS COMPONENTS (29 CFR 1910.1200)

ENGINEERING CONTROLS: Good general ventilation should be sufficient to control airborne levels.

PERSONAL PROTECTIVE EQUIPMENT

EYES AND FACE: Wear safety glasses with side shields or goggles.

SKIN: Use Nitrile/ Vinyl gloves

RESPIRATORY: NIOSH respirator -(organic vapor) in absence of proper environmental control.

PROTECTIVE CLOTHING: Clean, body-covering clothing

9. PHYSICAL AND CHEMICAL PROPERTIES

PHYSICAL STATE: Liquid

ODOR: hydrocarbon odor

APPEARANCE: Clear Liquid

pH: Not applicable

PERCENT VOLATILE: 100

VAPOR PRESSURE: Not Available

VAPOR DENSITY: >1 (Air=1)

BOILING POINT: ~ 85°C

FREEZING POINT: Not Available

SOLUBILITY IN WATER: Insoluble

SPECIFIC GRAVITY: ~.75 gm/ml

(VOC): ~100 % by weight

10. STABILITY AND REACTIVITY

STABLE: YES

HAZARDOUS POLYMERIZATION: NO

CONDITIONS TO AVOID: Oxidizing materials.

11. TOXICOLOGICAL INFORMATION

SENSITIZATION: not available

TARGET ORGANS: not available

CARCINOGENICITY:

IARC: Listed by IARC- NO

NTP: Listed by NTP- NO

OSHA: Listed by OSHA- NO

MUTAGENICITY: not available

REPRODUCTIVE EFFECTS: not available

NEUROTOXICITY: not available

12. ECOLOGICAL INFORMATION

ENVIRONMENTAL DATA: not available

ECOTOXICOLOGICAL INFORMATION: not available

13. DISPOSAL CONSIDERATIONS

DISPOSAL METHOD: Dispose in accordance with local, state, and federal laws.

14. TRANSPORT INFORMATION

DOT (DEPARTMENT OF TRANSPORTATION)

PROPER SHIPPING NAME: FLAMMABLE LIQUID, N.O.S., (CONTAING STODDARD SOLVENT)

PRIMARY HAZARD CLASS/DIVISION: 3

UN/NA NUMBER: 1993

PACKING GROUP: II

15. REGULATORY INFORMATION

UNITED STATES

DOT LABEL SYMBOL AND HAZARD CLASSIFICATION

DOT Flammable Liquid

CANADA

WHMIS HAZARD SYMBOL AND CLASSIFICATION

WHMIS Toxic

WHMIS Combustible Liquid

16. OTHER INFORMATION

PREPARED BY: Tony Casmus

REVISION SUMMARY Revision #: 1

This MSDS replaces the February 22, 2001 MSDS. Any changes in information are as follows:

MANUFACTURER DISCLAIMER: The information in this MSDS was obtained from current and reputable sources. However, the data is provided without any warranty, express or implied, regarding its correctness or accuracy. It is the user's responsibility both to determine safe conditions for use of this product and to assume liability for loss, injury, damage or expense resulting from improper use of this product.