............TOOLS REQUIRED
MALLET ............ELECTRIC DRILL
1/2" WRENCH.........DRILL BITS:
3/8" WRENCH.......1/8 - 3/16 - 1/4

IF YOU HAVE PURCHASED READY-TO-PAINT EURO STEPS, WE RECOMMEND APPLYING THE STEP TREAD AFTER ALLOWING PAINT TO THOROUGHLY DRY AND BEFORE BEGINNING INSTALLATION.

.............................................APPLICATION OF STEP TREAD
NOTE: USE CARE WHEN INSTALLING THE STEP TREAD. DUE TO THE STRONG BOND OF THE ADHESIVE IT CANNOT BE TAKEN UP AND REPLACED.

1. SET BOARDS ON A FIRM, EVEN SURFACE.

2. CLEAN STEP SURFACE OF RUNNING BOARD WITH GLASS CLEANER. LET DRY COMPLETELY.

3. POSITION TREAD, DO NOT REMOVE BACKING AT THIS TIME AND CLAMP POINT IN PLACE USING A LENGTH OF WOOD TO GIVE AN EVEN DISTRIBUTION OF PRESSURE.

4. CAREFULLY LIFT UP BACK EDGE OF STEP TREAD AND REMOVE BACKING. PRESS IN PLACE STARTING AT THE CENTER AND WORKING OUTWARD.

5. UNCLAMP WOOD AND REMOVE BACKING FROM CENTER STRIP. PRESS IN PLACE, AGAIN STARTING AT THE CENTER AND WORKING OUTWARD.

6. FINALLY, REMOVE BACKING FROM FRONT STRIP AND PRESS IN PLACE IN THE SAME MANNER AS THE OTHER STRIPS.

IMPORTANT
BEFORE BEGINNING INSTALLATION, DETERMINE WHETHER BRACKETRY WILL ATTACH DIRECTLY TO FRAME AS IN ILLUSTRATIONS 1,2,3 OR WHETHER A VERTICAL ANGLE SUPPORT WILL BE REQUIRED AS SHOWN IN ILLUSTRATION 4. THE BRACKET KIT CONTAINS SUFFICIENT COMPONENTS FOR ALL APPLICATIONS SHOWN.

51" & 55" EURO CLASSIC STEPS WILL REQUIRE TWO BRACKETS PER SIDE.
64", 73", & 87" WILL REQUIRE THREE BRACKETS PER SIDE.